DT01ACA200 Hitachi PCB 0A90380

PCB 0A90380 for Toshiba 2TB SATA 3.5" Hard Drive DT01ACA200

Board Number: 0A90380
Board Number: 110 0A90380 01, 220 0A90380 01

Suit for HDD: DT01ACA200 Toshiba 2TB SATA 3.5" Hard Drive

IBM Hitachi PCB Compatibility: IBM Hitachi PCB Replacement

Category: Hard Drive PCB - Hitachi PCB

Product Images:

DT01ACA200 Hitachi PCB 0A90380

A hard disk drive (HDD), hard disk, hard drive, or fixed disk, is an electro-mechanical data storage device. The "hard drive pcb" is also called "hard drive logic board", "hard drive controller board", "hard drive circuit board", or simply "hard drive board". This is the (often green) printed circuit board attached to the bottom of your hard drive. You can repair your defective hard disk drive by hard drive pcb replacement.

Please read before purchasing:

• These are just PCB (Printed Circuit Boards/Electronics Boards), not the whole HDD (Hard Disk Drive);
• We only charge shipping fee excluding customs fee. Most customers haven't been charged the Customs fee. If you will be charged the fee, you should be responsible for it.
• Most of the PCB are second hand. However, all boards have been fully tested before shipment;
• All PCB are used as data recovery/repair issues, there is no refund/exchange policy;
• It is a buyer responsibility to know if the board is adequate for his hard drive model;
• In most cases, you should exchange the BIOS/Main Controller IC before you swap hard drive PCB, in order to make the replacement board compatible with your HDD.
• Hard drive failures are NOT always caused by PCB failure. We cannot guarantee your drive to be repaired by replacing the hard drive PCB;

T6/T8 Star Screw Driver
If you don't have the suited screw driver to take off PCB from HDD, you can order one with the PCB. We will deliver the matching screw driver with your PCB.