Product Description:
Western Digital 2060-771824-003 SATA board PCB
Board Number:
2060-771824-003Board Version: REV A, REV B, REV C, REV P1, REV P2 (They are compatible! Ship randomly.)
Main Controller IC: 88i9346-TFJ2
Suit for Western Digital hard drives: WD20EZRX, WD20EURS, WD5000AZdX, WD20EZRX, WD15EZRX, WD20EFRX, WD30EURS, WD30EFRX, WD30EZRX, etc.
Category: Western Digital HDD PCB > Western Digital SATA PCB
WD PCB boards compatibility: Western Digital PCB swap guide
Western Digital 2060-771824-003 SATA board PCB
The hard drive PCB, also called "hard drive circuit board", "hard drive controller board", "hard drive logic board" or simply "hard drive board (card)" is screwed to the back of the hard disk drive (HDD). HDDZone.com: Donor PCB for data recovery purpose, you can repair your failed hard disk (disc) drive through a change or replacement of PCB boards.
Before you purchasing please read:
1. These are just PCB (Printed Circuit Boards/Electronics Boards), not the whole HDD (Hard Disk Drive);
2. Most of the PCB are second hand. However, all boards have been fully tested before shipment;
3. All PCB are used as data recovery/repair issues, there is no refund/exchange policy;
4. It is a buyer responsibility to know if the board is adequate for his hard drive model;
5. In most cases, you should exchange the BIOS/Main Controller IC before you swap hard drive PCB, in order to make the replacement board compatible with your HDD.
6. Hard drive failures are NOT always caused by PCB failure. We cannot guarantee your drive to be repaired by replacing the hard drive PCB;
T6/T8 Star Screw Driver
If you don't have the suited screw driver to take off PCB from HDD, you can order one with the PCB. We will deliver the matching screw driver with your PCB.
Western Digital PCB 2060-771824-003 Repair
When a circuit board fails, the below failure symptoms are may be caused by failure PCB:
* HDD can't spin up. Either no sound or a short, quiet tickling sound can be heard.
* A burning smell can be sensed coming from the HDD or PCB.
* PCB is extremely hot.
* There is obvious damage on the PCB board.
* If the hard drive simply can't be detected, or if it is clicking, then it could be a circuit board problem.
When you are very positive the PCB is dead, replacing a defective hard drive circuit board is an easy way to repair your PCB.
