WD PCB 2060-800041-003

Product Description:

PCB 2060-800041-003 Western Digital USB 3.0 Hard Disk Drive Circuit Board Controller Logic Board

Board Number: 2060-800041-003
Board Version: 2060-800041-003 REV A, 2060-800041-003 REV P1, 2060-800041-003 REV P2 (They are compatible! Ship randomly.)
Suit for Western Digital HDDs: WD30NMZW-11GX6S1 Western Digital USB 2.5" HDD, WD30NMZW-59GX6S1 Western Digital USB 2.5" HDD, WD40NMZW-59GX6S1 Western Digital USB 2.5" HDD, etc.

Category: Western Digital HDD PCB > Western Digital SATA PCB

WD PCB boards compatibility: Western Digital PCB swap guide

Western Digital 2060-800041-003 PCB

Western Digital 2060-800041-003 PCB

Before you purchasing please read:

1. These are just PCB (Printed Circuit Boards/Electronics Boards), not the whole HDD (Hard Disk Drive);
2. Most of the PCB are second hand. However, all boards have been fully tested before shipment;
3. All PCB are used as data recovery/repair issues, there is no refund/exchange policy;
4. It is a buyer responsibility to know if the board is adequate for his hard drive model;
5. In most cases, you should exchange the BIOS/Main Controller IC before you swap hard drive PCB, in order to make the replacement board compatible with your HDD.
6. Hard drive failures are NOT always caused by PCB failure. We cannot guarantee your drive to be repaired by replacing the hard drive PCB;

T6/T8 Star Screw Driver
If you don't have the suited screw driver to take off PCB from HDD, you can order one with the PCB. We will deliver the matching screw driver with your PCB.

WD PCB 2060-800041-003 Repair
When a circuit board fails, the below failure symptoms are may be caused by failure PCB:

* HDD can't spin up. Either no sound or a short, quiet tickling sound can be heard.
* A burning smell can be sensed coming from the HDD or PCB.
* PCB is extremely hot.
* There is obvious damage on the PCB board.
* If the hard drive simply can't be detected, or if it is clicking, then it could be a circuit board problem.