Product Description:
WD2500AAKS Western Digital Hard Drive PCB Logic Controller Circuit Board 2060-701590-001 REV A
Main Controller IC: 88I8864-TFJ2;
HDD Motor Combo IC (Smooth Chip): L7251 3.1;
Board Number: 2060-701590-001 REV A;
WD PCB boards compatibility: Western Digital PCB swap guide
Type I (PCB 2060-701590-001 without BIOS)
Type II (PCB 2060-701590-001 with BIOS)
A hard disk drive (HDD), hard disk, hard drive, or fixed disk, is an electro-mechanical data storage device. The "hard drive pcb" is also called "hard drive logic board", "hard drive controller board", "hard drive circuit board", or simply "hard drive board". This is the (often green) printed circuit board attached to the bottom of your hard drive. You can repair your defective hard disk drive by changing or replacing the circuit boards.
Before you purchasing please read:
1. This is just a hard drive circuit board (PCB, Logic board), not the whole hard drive;
2. HDD PCB board number is printed on the board, not on the sticker;
3. These boards are USED, NOT brand new, the circuit board components not falling, the interface did not break. All PCBs have been tested before shipping;
4. It is used for data recovery/repair issues, the PCB board has been tested and in good working condition. There is no refund/exchange policy;
5. You should swap the BIOS chip before you exchange the PCB boards, as our guide sticker shown, in order to make the replacement board compatible with your hard drive;
6. It is the buyer's responsibility to know whether the board is adequate for his hard drive model;
7. Hard drive failures are NOT always caused by PCB failure. We cannot guarantee your hard drive to be repaired by replacing the hard drive PCB;
T6/T8 Star Screw Driver
If you don't have the suited screw driver to take off PCB from HDD, you can order one with the PCB. We will deliver the matching screw driver with your PCB.
PCB Data Sheet: WD2500AAKS Western Digital 250GB SATA 3.5" Hard Drive PCB
